Students will learn methods to properly deploy and configure their switching and routing environments using the ExtremeXOS/SwitchEngine CLI. This knowledge will be reinforced through actual hands-on experience with networking equipment in a lab environment, where students will perform real world tasks.

This course provides the knowledge and skills necessary to deploy Extreme Networks’ ExtremeCloud IQ - Controller. Students experience the deployment process from the beginning to completion, learning all the essential steps and technologies. Lectures are supported with hands-on
experience with ExtremeCloud IQ - Controller and relevant access points. Successful completion results in an operational WLAN with Open SSIDs, encryption and authentication, configuration settings, AP discovery, and equipment profiles used in the creation and management of Sites in ExtremeCloud IQ - Controller.

Students will be introduced to Extreme Network’s network access control solution, ExtremeControl. Students will learn methods to properly install and configure their ExtremeControl engines. Use cases and deployments for ExtremeControl within different network models are also discussed. The primary ExtremeControl use case covered in this course is visibility of end-systems with Passive and Pass-Through Modes. Components of authentication to include proxying RADIUS are discussed. Students will have these concepts reinforced with hands-on lab experience installing ExtremeControl into a preconfigured network.

This course provides an in depth review of Extreme Networks’ Fabric Connect advanced features for integrating SPBM with other protocols and solution requirements. You will learn how Fabric Attach signaling is used to provision services at the edge and how expand the campus configuration by implementing Fabric Extend and Multi-Area SPBM. Redistributing routes from outside protocols into IS-IS is discussed with route policies. You’ll also learn about how DvR provides Default Gateway Redundancy and optimizes traffic flows. Lectures are supported with hands-on configuration of VSPs, Universal Hardware 5520, ERS, and EXOS.

This course will enable you to install and configure an ExtremeCloud SD-WAN solution including the major Site types: Bridge mode, Router mode, Hybrid mode and Remote Visibility Control (RVC) Site. You will gain an understanding of the concepts and functionality of the SD-WAN architecture through comprehensive lectures and discussions. By performing the labs, you will experience onboarding the appliances with ExtremeCloud SD-WAN Orchestrator and validating network application flow.

Extreme Networks’ Fabric Connect is an advanced, reliable, high performance network solution. This training course will review the technologies that support the fabric operation and services highlighting their proper operation and ways to determine misconfiguration. Identifying problems at network Layer 1, Layer 2 and Layer 3 and discussed along with how to troubleshoot fabric service issues. Lectures are supported equally with hands-on troubleshooting activities on VSPs, Universal Hardware 5520, ERS, and EXOS.